Page 1 of 1

No Sensors

PostPosted: Mon Dec 11, 2023 2:28 pm
by patrick-voelkl
Hi at all,

when i am Start Goverlay, i became this error massage an no sensors are showed. Can someone help?

Re: No Sensors

PostPosted: Mon Dec 11, 2023 11:17 pm
by TheLaGmAn
We already had a teamviewer session to go over the issue and Its been fixed on GOverlayPlus 2.0.11, but do let me know if it appears again for some reason, and if anyone else is on 2.0.11 and encounters this issue, please let me know as well

Re: No Sensors

PostPosted: Wed Dec 20, 2023 3:33 pm
by Azyate
Hey i get nearly the same Error, but my version is 2.0.9 it says i have the latest Version where can i get the 2.0.11?

Re: No Sensors

PostPosted: Wed Dec 20, 2023 3:45 pm
by TheLaGmAn
a message should appear when you open goverlay saying there is a new version, if it doesnt, go to Help > WhatsNew > Check for new version, see if it prompts you to update

Re: No Sensors

PostPosted: Wed Dec 20, 2023 4:22 pm
by Azyate
Thank you, the errors I'm encountering are still present. These errors originate from Open Hardware Monitor when the exe is open.
Screenshot 2023-12-20 170535.png
Open HM
Screenshot 2023-12-20 170535.png (10.59 KiB) Viewed 11874 times



Unfortunately, SIV is also not being recognized on my end. I have enabled it in Goverlay and SIV started but it always says that it couldn't be found.
Screenshot 2023-12-20 171259.png
Screenshot 2023-12-20 172118.png

Re: No Sensors

PostPosted: Wed Dec 20, 2023 4:47 pm
by TheLaGmAn
can you send me an email to support@goverlay.com and we do a anydesk session to check the issue?

Re: No Sensors

PostPosted: Wed Dec 20, 2023 8:46 pm
by TheLaGmAn
thanks Azyate for helping into solving this issue.
For anyone else having issues with OHM/SIV, make sure you are on GOverlay 2.0.17